IZI1

Studio Technologies Model 348 8-Channel Dante Tabletop Intercom Station

No reviews
B&H Photo Video
USD 1,845.00

at B&H Photo Video

About this item

Whether you need full audio control in broadcast, live events, theater, or even aerospace applications, the Model 348 8-Channel Dante Tabletop Intercom Station from Studio Technologies provides an impressive set of features. Eight independent talk and listen channels are controllable for virtual party lines via Dante audio-over-Ethernet protocol. Built-in features, including support for 5-pin female XLR headsets, 3.5mm 4-conductor TRRS CTIA headsets, and 1/4" gooseneck microphones, allow you to communicate with on-air talent. The built-in speaker makes this unit great for hearing talent right out of the box.

Audio Channels and Headset Connections

On the front of the unit lie eight independent controls for on-air talent to adjust talk channel levels. Each channel has an associated RGB LED button that can mute, solo, and indicate associated audio inputs.

Dante Audio-over-Ethernet

At the heart of Model 348's operation is the Dante Audio-over-Ethernet protocol. With a single Ethernet cable connected to the primary RJ45 port, located on the rear panel, up to 16 inputs and 12 outputs are available for channel routing. For redundant backup, a secondary RJ45 port can be utilized in case of potential power issues from other equipment.

Audio Fidelity

Quality and resolution are not an issue with Model 348, thanks to a supported sample rate of 48 kHz and bit depth of up to 32. Regarding the analog portion of the unit, each microphone/headset input features a low-noise, wide dynamic range preamplifier and a voltage controller amplifier (VCA) compressor to minimize the chance of signal overload. Lastly, for specific configurations, Quindar tones are available for sending intro and outro cues to talent.

Versatile Power Options

The Model 348 can be powered by Power-over-Ethernet (PoE) via the RJ45 connection or a standard 4-pin XLR female DC power supply (10-18 volts).

  • Features
    • For Broadcast Applications
    • Dante Audio-over-Ethernet Technology
    • Eight Independent Talk & Listen Channels
    • 5-Pin Female XLR Headset Connector

Specifications

Applications

Dante-Based Intercom, Broadcast IFB (Talent Cue) Master Station, Audio Monitor Mixer, Aerospace (Including Capsule Communicator (CapCom)), and Specialized Tone Generation

Network Audio Technology

Type: Dante Audio-Over-Ethernet AES67-2018 Support: Yes, Selectable On/Off Dante Domain Manager (DDM) Support: Yes Ethernet Interface Configuration: Switched or Redundant Bit Depth: 16, 24, or 32 Sample Rate: 48 kHz Number of Dante Receiver (Input) Channels: 16 Number of Dante Transmitter (Output) Channels: 12 Number of Dante Flows: 16 Receiver, 16 Transmitter Internal Digital Audio Processing: 32-Bit, Fixed Input-to-Output Audio Processing Latency: <200 uSec Nominal Input and Output Level: -20 dBFS

Network Interface

2, Primary (PRI) and Secondary (SEC) Type: 1000BASE-T Gigabit Ethernet (GbE) per IEEE 802.3ab (10 and 100 Mb/s Not Supported)

Microphone Input

Compatibility: Gooseneck, Studio Technologies' GME-3-12 Microphone Power: 3.3 VDC via 2.49 Kilohms Resistor Impedance: 3.3 Kilohms, Nominal Gain: 12, 18, 24, 30, 36, 42 dB, Selectable Frequency Response: -3.0 dB at 40 Hz, -2.0 dB at 50 Hz, -2.0 dB at 16 kHz, -3.0 dB at 20 kHz Distortion (THD+N): 97 dB, A-Weighted, 12 dB Gain

Compressor

Application: Applies to Headset and Gooseneck Microphone Audio Threshold: 1 dB Above Nominal Dante Transmitter (Output) Level (-19 dBFS or -13 dBFS when Gooseneck Mic Gain Selected for 42 dB) Slope: 2:1

Dante / AES67 Channels

8 Monitor 7 Auxiliary 2 Monitor Outputs

Headphone Output

Type: 2-Channel (Stereo) Compatibility: Intended for Connection to Stereo (Dual-Channel) or Monaural (Single-Channel) Headsets with a Nominal Impedance of 50 Ohms or Greater Maximum Output Voltage: 3.0 Vrms, 1 kHz, 150 Ohms Load Frequency Response: 20 Hz to 20 kHz, +0/-1 dB Distortion (THD+N): 93 dB Dim (Attenuation): 0, 6, 12, 18 dB, Configurable

Speaker Output

Type: Single-Channel (Monaural) Speaker: 1.3" / 32 mm Diameter Maximum Power: 4 Watts RMS, Nominal Frequency Response: 250 Hz to 20 kHz, ±3 dB Dim (Attenuation): 0, 6, 12, 18 dB, Configurable

Call Functions

Receive Frequency: 20 kHz, ±800 Hz, within Audio Channel Receive Level: -27 dBFS Minimum Send Frequency: 20 kHz Send Level: -20 dBFS Audible Alert: 3-Burst Sequence, 524 Hz, Sine Wave, Selectable Level Range

Remote Control Input

Inputs: 2 Function: Configurable, Can Mimic the Action of Two Talk Buttons Type: Active Low, 1 mA Maximum, Input Pulled up to 3.3 Volts DC via 3.4-Kilohm Resistors

Power Sources

Power-over-Ethernet (PoE): Class 3 Mid-Power, less than or equal to 12.94 Watts) per IEEE 802.3af DC Input: 10 to 18 VDC, 1.1 A Maximum at 12 VDC

Connectors

Headset A: 5-Pin Female XLR Headset B: 3.5 mm 4-Conductor TRRS Jack, per Japanese Standard JEITA/EIAJ RC-5325A Gooseneck Microphone: 3-Conductor 1/4" with 7/16-20 UNF Threaded Bushing; 4-40 UNC Hex Head Socket Set Screw Allows Microphone to Be Secured into Bushing Ethernet: 2, Neutrik NE8FBH etherCON RJ45 Jacks (Compatible with etherCON CAT 5 Plugs) DC Input: 4-Pin Male XLR (Pin 1 Negative, Pin 4 Positive) USB A Receptacle (Used Only for Updating Firmware) Remote Control Inputs: 3-Pin Header Located on the Main "Broadway" Circuit Board Headset Microphone Input: 3-Pin Header Located on the Analog Circuit Board Headset Phones Output: 3-Pin Header Located on the Analog Circuit Board

Configuration

Requires Studio Technologies' STcontroller Software Application

Software Update

USB Flash Drive Supports Updating of Main MCU, Secondary MCU, and FPGA Firmware (Embedded Software); Dante Interface Firmware Updated via Ethernet Interface

Environmental

Operating Temperature: 32 to 122°F / 0 to 50°C Storage Temperature: -40 to 158°F / -40 to 70°C Humidity: 5 to 95%, Non-Condensing

Dimensions

6.5 x 4.9 x 2.9" / 16.5 x 12.5 x 7.4 cm

Weight

2.1 lb / 1 kg

Package Weight

2.47 lb

Box Dimensions (LxWxH)

9.2 x 7.2 x 5.7"

Product photos are for illustrative purposes only and are exemplary. The colors, inscriptions, parameters, dimensions, sizes, functions, and/or any other features of the original products may look different than in reality due to their visual characteristics, so please refer to the product features that are indicated in the product descriptions.

You may also like